Bogen Wireless Office Headset ADP1 User Manual

Analog Door Phone  
Model ADP1  
Installation and Use Manual  
© 2004 Bogen Communications, Inc.  
All rights reserved.  
Specifications subject to change without notice.  
54-2098-01B 0607  
 
Description  
TheADP1 is a convenient remote,weatherproof,hands-free two-way terminal device for  
telephone systems.  
The unit is telephone line powered and includes adjustable microphone and speaker vol-  
ume levels as well as a selectable Auto Answer feature to allow for remote monitoring.  
The ADP1 also includes an adjustable and defeatable call timer and can respond to  
forward disconnect signals.  
The ADP1 features a heavy-gauge stainless steel gasketed faceplate, plastic cone speaker,  
and faceplate to electrical box (user supplied) gasketing to protect against vandals and  
varying weather conditions. A dress bezel is included with the unit for trimming out  
rough openings in flush mount applications.  
Package Contents  
(1) ADP1  
(4) Hex drive screws  
(1) Hex wrench  
(1) Bezel  
(1) Bezel gasket  
3
 
Settings  
ADP1  
PC Board  
7
NOISE  
REDUCTION OFF  
4
5
1. TEL Line Connector - Analog station line connection (Tip and Ring) is made via  
an RJ11 connector that is pre-wired to a 2-position pluggable terminal block. The  
connections to the terminal block are not polarity sensitive. (See Wiring, pg. 5.)  
2. Speaker Volume POT - The Speaker Volume POT controls the speaker volume  
level of the unit. Clockwise rotation (looking at POT) increases the volume.  
3. Microphone Level POT - The Microphone Level POT adjusts the microphone  
return talk level of the unit. In certain noisy locations (e.g., background traffic,  
machinery, or wind) the microphone threshold level may need to be decreased, oth-  
erwise the unit might detect the background noise as valid audio thereby causing the  
unit to remain in the talk mode. Clockwise rotation (looking at POT) increases the  
return talk level.  
4. Noise Reduction - Slowly mutes the level to the phone when only  
background noise, not active audio, is detected.  
5. Active LED - For use when installing and troubleshooting, the LED indicates that  
the unit is active (off hook) when lit.  
6. Timer / Timer Duration POT - The ADP1 can be configured to  
automatically disconnect a call after a preset amount of time has  
elapsed.The timer can be set between 15 seconds and 2 minutes.The  
timer is activated by pressing the button on the unit or when the unit answers (Auto  
Answer) an incoming call.With the timer disabled, the call time will be unlimited and  
the ADP1 will not disconnect the call until a 300 ms or longer loss of loop current  
is detected.If the telephone line/phone system extension does not supply a loop cur-  
rent break when the calling party hangs up, then the call timer feature must be used  
(enabled). Clockwise rotation of the POT increases the duration.  
7. Auto Answer - The ADP1 can be configured to automatically  
answer an incoming call.This feature can be enabled or disabled using  
a jumper located on the PC board.  
4
 
Wiring  
Phone Connection  
TheADP1 comes with an RJ11 wired to the pluggable terminal block. Connect theADP1  
to the phone system’s analog station line programmed for ring down operation using the  
RJ11 or directly to the screw terminals depending on how the lines are terminated.The  
connections to the terminal block are not polarity sensitive.  
Surge Protection  
To increase surge protection, connect a protective Earth Ground to the spare lug  
provided. A ring lug is provided to which the protective ground lead is crimped.  
Reassemble the lug to post as shown.  
5
 
Installation  
The ADP1 is designed to fit in most standard dual gang electrical boxes. Make sure to  
use the proper box type for intended installation (e.g., flush or surface mount, indoor  
or outdoor location, etc.).  
Flush Mounting the ADP1 (Indoor/Outdoor)  
1. Cut rough opening and install  
appropriate electrical box.  
Note: The box must be flush with the  
surface within 1/16".  
2. For outdoor installations, caulk  
around the box, filling any gaps  
between the box and the rough  
opening.  
3. Attach the self-adhesive gasket to  
the back side of the bezel.  
4. Make electrical connections and  
attach the faceplate to the electrical  
box while capturing the bezel  
between the two using the four hex  
drive screws (tool provided).The  
faceplate fits into the depression in  
the bezel.  
Surface Mounting the ADP1  
(Indoor/Outdoor)  
1. Mount electrical box.  
2. Make electrical connections and  
attach the faceplate to the electrical  
box using the four hex drive screws  
(tool provided). Do not use the  
bezel for surface mount installations  
as the elevated sharp corners of the  
bezel could pose a hazard.  
6
 
Specifications  
Power:  
Telephone line powered  
(18V DC / 20 mA minimum)  
Timer Duration:  
Loop Current Loss Disconnect:  
RingVoltage:  
15 seconds to 2 minutes  
300 ms minimum  
40V AC RMS minimum  
0.7A  
REN:  
Connections:  
2-position pluggable terminal block  
Earth Ground lug  
1
Dimensions:  
5" W x 5" H x 2 /4" D (fully assembled)  
45/8" W x 45/8" H x 2" D (aluminum box)  
4 lb.  
Product Weight:  
7
 
Warranty  
The ADP1 is warranted to be free from defects in material or workmanship for two (2)  
years from the date of sale to the original purchaser.Any part of the product covered by  
this warranty that, with normal installation and use, becomes defective will be repaired  
or replaced by Bogen, at our option, provided the product is shipped insured and prepaid  
to: Bogen Factory Service Department, 50 Spring Street, Ramsey, NJ 07446, USA. The  
product will be returned to you freight prepaid.This warranty does not extend to any of  
our products that have been subjected to abuse, misuse, improper storage, neglect, acci-  
dent, improper installation or have been modified or repaired or altered in any manner  
whatsoever, or where the serial number or date code has been removed or defaced.  
THE FOREGOING LIMITEDWARRANTY IS BOGEN'S SOLEAND EXCLU-  
SIVEWARRANTY ANDTHE PURCHASER'S SOLE AND EXCLUSIVE REM-  
EDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER  
EXPRESS OR IMPLIED, AND ALL IMPLIED WARRANTIES OF MER-  
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HERE-  
BY DISCLAIMED AND EXCLUDEDTOTHE MAXIMUM EXTENT ALLOW-  
ABLE BY LAW. Bogen's liability arising out of the manufacture, sale or supplying of  
products or their use or disposition,whether based upon warranty,contract,tort or oth-  
erwise, shall be limited to the price of the product. In no event shall Bogen be liable for  
special, incidental or consequential damages (including, but not limited to, loss of profits,  
loss of data or loss of use damages) arising out of the manufacture, sale or supplying of  
products, even if Bogen has been advised of the possibility of such damages or losses.  
Some states do not allow the exclusion or limitation of incidental or consequential dam-  
ages, so the above limitation or exclusion may not apply to you.This warranty gives you  
specific legal rights, and you may also have other rights which vary from state to state.  
Products that are out of warranty will also be repaired by the Bogen Factory Service  
Department — same address as above or call 201-934-8500.The parts and labor involved  
in these repairs are warranted for 90 days when repaired by the Bogen Factory Service  
Department. All shipping charges in addition to parts and labor charges will be at the  
owner's expense.All returns require a Return Authorization number.  
8/10/2004  
50 Spring Street, Ramsey, NJ 07446, U.S.A.  
Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com  
 

Belkin Network Router A F5D7130 User Manual
Black Box Switch Video Matrix Switches User Manual
Bogen Intercom System CM 206M User Manual
Bolens Lawn Mower 189 421 000 User Manual
Bolens Snow Blower 1026 User Manual
Bosch Appliances DVR DVR600 User Manual
Braun Electric Toothbrush OC 17545X User Manual
Briggs Stratton Pressure Washer 2650 PSI User Manual
Brunton Boating Equipment V2 PRO User Manual
Carcomm PDAs Smartphones CHFS 98 User Manual